单片机课程设计-实时时钟（国外英文资料）.doc

单片机课程设计-实时时钟（国外英文资料） ; * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * ; * ; * ; Wired: the third foot of the dial switch is allocated to the ON direction, which is to power the digital tube ; The 5th foot of the dial switch is set in the direction of ON, which makes the buzzer ring a bit ; * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / CODE_SEG SEGMENT CODE DATA_SEG SEGMENT DATA RSEG DATA_SEG DIS_INDEX: DS 1 DIS_DIGIT: DS 1 KEY_S: DS 1 KEY_V: DS 1 SECCNT: DS 1 Stack: DS 60 DIS_BUF: DS 8 XmtDat: DS 1 30 h BitCnt data; Data bit counter ByteCnt data of 31 h; Data byte counter The Command data 32 h; Command byte address TIME_DATA DATA 40 Secant: SEC, TIME_DATA MIN: TIME_DATA + 1 HOUR - - - TIME_DATA + 2 HOUR_H. The hours of ten HOUR_L. Hours bits MIN_H. Points ten MIN_L. Points bits SEC_H is DIS_BUF + 6; The second ten SEC_L. Second bits ; Port a definition SCLK BIT P3.4; Clock control bus IO_DATA BIT P3.5; Data transfer bus RST BIT P3.7; Reset the bus AN1 BIT P3.2 AN2 BIT P3.3 SPK BIT P3.6 CSEG AT 0000 h LJMP MAIN CSEG AT 0000 bh LJMP TIMER0 CSEG AT 001 bh LJMP TIMER1 RSEG CODE_SEG MAIN: The CLR RST MOV SP, # (stack -1); Initialize the stack pointer MOV P1, # 0 FFH MOV P2, # 0 FFH MOV TMOD, # 11H; Timer 0, 1 working mode 1, 16 timing methods MOV TH0, # 0 FCH MOV TL0, # 017 h MOV TH1, # 0 DCH The CLR a. MOV TL1, a. MOV, IE # 082 h MOV DIS_DIGIT, # 0FEH The CLR a. MOV DIS_INDEX, a. MOV DIS_BUF + 02H MOV DIS_BUF + 05H MOV TIME_DATA, # 57h; The content of the second unit is 59h MOV TIME_DATA + 1 The unit contents are 59h MOV TIME_DATA + 2, # 11h; The unit contents are 11h MOV TIME_DATA + 3, # 21h; MOV TIME_DATA + 4 MOV TIME_DATA + 5MOV TIME_DATA + 6, # 0 MOV TIME_DATA + 7, # 0 Write the protection unit content as 00h MOV P1. Initializes the I/O port M