6082铝合金板带热连轧规程优化.pdfVIP

第 20 卷第3 期 Vo l. 20 No.3 在性二程等粮 2013 年 6 月 JOURNAL OF PLASTICITY ENGINEERING Jun. 2013 doi: 10. 3969/j. issn. 1007-2012. 2013. 03. 004 6082 铝合金板带热连轧规程优化养 (北京科技大学冶金工程研究院，北京 100083) 陈振华 蔡庆伍 宋 勇 孙超凡 摘 要:根据应力随应变、变形温度和应变速率变化的数据，利用 MATLAB 软件拟合 6082 铝合金的变形抗力模 型;利用测试函数对基本粒子群算法 (BPSO) 和改进粒子群算法 CIPSO) 的性能进行对比，结果表明， IPSO 在 收敛速度和精度上均优于 BPSO。利用 IPSO，在设备、工艺约束下，以能耗、板形为目标函数，对 6082 铝合金的 4 机架热连轧规程进行优化，并将优化结果与以等压下率分配的规程进行对比，结果表明，优化后的规程，其能耗 和板形均优于等压下率制定的规程，对实际生产有一定的指导意义。 关键词:热连轧;规程优化;变形抗力模型;改进粒子群算法 中固分类号: TG335.1 文献标识码:A 文章编号: 1007-2012 (2013) 03-0022-04 Research on hot tandem rolling schedule of 6082 aluminum alloy plate CHEN Zhen-hua CAI Qing-wu SONG Yong SUN Chacγfan (National Engineering Research Center for Advanced Rolling Technology , University of Science and Technology Beijing , Beijing 100083 China) Abstract: Matlab was used to fit the deformation resistance model according to the data of stress with different strain , deforma- tion temperature and strain rate conditions. The performances of basic particle swa口丑 algorithm (BP叹)) and the improved parti cle swarm algorithm CIPSO) was compareιResult demonstrates that IPSO has higher calculation accuracy and faster conver- gence speed. Based on IPSO in the constraints of equipment and process , energy consumption and shape were used as the target function to optimize the hot tandem rolling schedule of 6082 alloy. In contrast with the result of equal pressure ratio , the optimi- zation are better both in energy consumption and shape. Keywo时s: hot strip mills; rolling schedule optimization; deformation resistance model; improved particle swa口口 optimization