移动通信中各类数字调制方法的剖析比拟（国外英文资料）.docVIP

移动通信中各类数字调制方式的分析比较（国外英文资料） At present, according to the mobile communication system development process and the communication service requirements is different, each modulation methods used by mobile communication system also has a characteristic, shown in the table below: Table: the modulation method adopted by each mobile communication system The standard service type is mainly modulated GSM cell GMSK The IS - 95 cellular upward: OQPSK down: BPSK PHS no rope PI / 4 - DQPSK CDMA2000 cellular QPSK and BPSK WCDMA cellular QPSK and HPSK Td-scdma cellular QPSK and 8PSK B3G (4G) honeycomb OFDM and its related technologies 1.1 GMSK modulation method GSM systems GSM systems use a modulation method called GMSK. GMSK has optimal overall performance in binary modulation. Its basic principle is to make the baseband signal through gaussian filter filter first, make the baseband signal form the gaussian pulse, after MSK modulation, belongs to the constant envelope modulation scheme. Its advantage is that it can maintain the spectral efficiency while maintaining the corresponding wave channel and adjacent channel interference, and the envelope is constant, which is easier to implement. Currently, the phase-locked loop (PLL) type GMSK modulator is used. As you can see its modulation principle, the phase modulation method selects 90 ° phase shift, each phase shift only a bit, although in the signal transmission are the benefits of such considerable will happen in the process of phase and amplitude error, but it will not disrupt the receiver, which will not generate the error, against the ability of phase error is very strong. If the phase decoding error occurs, only one data bit is lost. This created a very stable of the digital voice transmission system, it is also the modulation mode in the second generation mobile communication system is widely used in one of the important reasons. But the only drawback is that the data transfer rate is relatively low, and the spectrum is less