网管常用做网线的方法和8根网线的分别作用（国外英文资料）.docVIP

网管常用做网线的方法和8根网线的分别作用（国外英文资料） There are two ways of doing it, one is crossing, one is parallel Crossing the line is: one side adopts 568A standard, one USES 568B standard The parallel line is: both of these are the same as the 568A standard or the 568B standard, which is used for the 568B parallel line. 568A standard: green white, green, orange white, blue, blue white, orange, brown white, brown 568B standard: orange white, orange, green white, blue, blue, white, green, brown, brown You can notice that the difference between the two is orange and green. Use parallel lines, such as a computer connection to a router or switch, if the connection is not equal If the two devices connected are equivalent, use a cross line, such as a computer connected to a computer I hope my answer will help you Its just a normal connection! But you can do both! Because the normal net line USES only 1.2.3.6 other if not be connected to be able to use the same! ~ There are two international standards for the production of double stranded wires: EIA/TIA568A and EIA/TIA568B. There are two main ways to connect the double stranded wire, which is the direct line and the cross wires. Say simply, straight-through cable is crystal head on both ends at the same time using standard T568A or T568B wiring, and the crossover cable is made by the T586A standard crystal head end, while the other end USES T568B standard production, is A crystal head of corresponding crystal head B 1, 2, 3, 6, and A crystal head 3, 6 corresponding B crystal head 1, 2. String 5 The sequence of lines described in T568A is from left to right: The line sequence described by the T568B standard is from left to right: And in what case should it be made straight, and where should the cross cables be used? Next, Ill give you a quick list. Add a point, the same device is connected by cross wire, different equipments are connected to use straight line!! Step 3: we need to untangle each pair of cables that are intertwined. When unsolve