塔式起重机测验试卷(国外英文资料).docVIP

塔式起重机考试试卷(国外英文资料) The tower crane driver takes the test 1, to judge: to draw the square root correctly. The size of a tower crane is QTZ40, and its 40 means that the tower crane weighs 40 tons. (a) Electrical systems include motors, controllers, power distribution cabinets, wiring, signals and lighting fixtures. (a) When operating switch button, handle, not too hard, change gear shift should be smooth, step by step, switch, use as much as possible. (a) Before leaving work, the total power supply should be cut off from the main source (except for the barrier lamp line), the various instructions should be transferred to 0, and carefully make the record of the taiban. (a) 5, tower crane luffing indicator, torque limiter and various travel limit switch with safety protection device must be complete, sensitive and reliable, shall not be adjusted freely and removal; The operating mechanism can be stopped using a limiter. (a) The control controller must start at zero and push to the desired gear level. When the gear is moving in the opposite direction, the controller goes back to zero, then the reverse operation, the more the operation and the emergency stop. ? (a) It is strictly forbidden to use a free-fall method to lower the hook or weight. When the weight falls about 1m from the site, do not have to take a slow position. (a) When the crane begins to work, the driver should first send out a sound signal to warn the crew of the job. (a) The lifting hooks and the various pulleys, the guide wheel and so on should rotate flexibly, the phenomenon of no carcasse, the steel wire rope should be in good condition, the fixed end should be strong and reliable. (a) Do not use hooks to hang heavy weights directly, the hooks must hang heavy weights with hanging and rigging. (a) When lifting short and broken materials, it must be packed in strong enough net and bag, and not be tied up directly. (a) 12,? When lifting heavy weights, it must not be violently fallen, in case of any loose