弹簧钢60Si2Mn脱碳层软化的表征与研究.pdfVIP

Vo!.36 No .3 第 36 卷第3 期 命品 专 址 ACTA METALLURG ICA SINICA March 2 0 0 0 2 0 0 0 年 3 月 弹簧钢60Si2Mn 脱碳层软化的表征与研究* 李家宝单明刘凤智末. J、平 盖秀颖 (中国科学院金属研究所材料疲劳与断裂国家重点实验室， 沈阳 110015) 擒 要 提出-种表征.u碳层软化的新方法，该方法倍骂自 X 射线应为分析技术测量屈服强度在脱碳层深度方向上的分布. 对弹簧钢 60Si2Mn 的脱碳层的屈服强度、 X 射线衍射线半高宽初是微硬度的层深分布作了对比利分析， 在此基础上指出利用新方法进行软化装 征有助于更深入闸明脱碳影响黛劳强度的机制.井有望建立某些定量关系， 关键词 弹簧钢.脱碳层.屈服强度 X 射线应用分析. JU量硬度 中回法分类号 TG1l5.22， T G 142.4 1 文献标识码 A 文意编号 0412-1961(2000)03-0287-04 CHARACTERIZATION AND INVESTIGATION OF SOFTENING IN DECARBURIZED LAYER OF SPRING STEEL 60Si2岛fn LI Jiabao , QIN Ming, LIU Fengzhi, SONG Xiaoping , GAI Xi v.ying State Key Laboratory for Fatigue and Fracture of Ma阳rial.s， Institute of Metal R眉earch， The Chin田e Academy of Scienc圈， Shenyang 110015 Co附spondent: LI Jiabao, professor, Tel: (024-55344, Fax: (024 Manuscript received 1999-07-19, in revised form 1999-11-05 ABSTRAC T A new method for charact erization of soft ening in a decarburized layer is proposed. The core of t h e method is measurement of the depth dist ribut ion of yield st rengt h in the la.yer using X- ray stress a.nalysis technique. Comparison an d analysis of depth distributions of yield strength, half-width of X-ray diffraction profile , and microhar dness in the decarburized layer of spring steel 60Si2Mn was made , and t he advantage of the new met hod was discussed . KEY WORDS spring steel 60Sí2Mn , decarburized la.yer , yíeld strength, X-ray stress an alysís, micrc• hardness 法还可以测量表层屈服强度在