橡胶密封件隔声性能测试实验室的设计(国外英语资料).doc

橡胶密封件隔声性能测试实验室的设计 Because the minimum test frequency of the acoustic lab is confirmed as 200Hz, reverberation room The net volume v must be greater than 70 m, , now the net empty space... V = 100 m, And, according to the The scale of the series, the length, width and height of the reverberation room are 5.84 m, 4.64 m and.. 3.68 m. In this dimension, the maximum linear (diagonal length) of the interior is 1 = 8.32 m, fully satisfied with the requirements of l 1.9 V 8.81 m. Wow - one... ... -] }. A.. ... . ; ! One by one.. Shoes seller { : I Chou The gangsters day mouth : : : = = The standard is the standard. = 1: Figure.. The graphic schematic of the reverberation chamber. The wall of reverberation room In order to strengthen the sound diffusion effect of reverberation chamber, it is perpendicular to each other The surface is set with an arched diffuser. The wall of the wall is used in the diffusion of the diffuser. 12 omm brick build by laying bricks or stones The other two circular arched diffuses are made of aluminum plates with a thickness of not less than 6mm Or the PvC plate is made into the wall and the surface density of the plate is greater than 4.5 kg. reverberation The internal structure of the room is shown in figure 1. To reduce the sound absorption of the reverberation chamber, enhance The sound reflects off all the walls and ceilings with white tiles, and the ground is paved with marble Surface. This treatment ensures that the acoustic absorption coefficient is less than 0.o2 105 The demand is neat and beautiful again. .. The wall of the room In order to reduce indoor background noise, at the same time reduce the construction cost, be satisfied to make The exterior wall of the reverberation room is... 240mm thick brick wall, roof is a double reinforced concrete prefabricated floor. .. 3.4 soundproof door The reverberation room needs an area of 1.2 m by 2.2 m, and the sound insulation is 35dB Soundproof door. The design of the sound chamber In accorda