TraSys428水性橡胶脱模剂.docx

Best Fluoro 佑孚TraSys428水性橡胶脱模剂DescriptionTraSys? 428 mold release coating is a water-based dispersion for hot mold applications. When properly applied to a mold,?it exhibits outstanding durability and antistick properties and has a very low coefficient of friction. TraSys? 428 is clean, nonoily, nonstaining, chemically inert, and can function in high temperatures.TraSys? 428 mold release coating has unique properties, making it an excellent release agent for molded rubber, molded fluoropolymer, molded plastic, and epoxy and plastic laminates. Unlike oily release agents, when properly applied, TraSys? 428 does not interfere with post-finishing operations.TraSys? 428 comes pre-diluted and is ready for use. Proper application results in superior release, and multiple release is normal.产品描述TraSys?428脱模涂料是一种用于热模具应用的水性分散体。当适当地应用于模具时，它表现出突出的耐久性和防粘性，并且具有非常低的摩擦系数。 TraSys?428是干净，非油性，无污染，化学惰性，可在高温下发挥作用。TraSys?428脱模涂料具有独特的性能，使其成为成型橡胶，模塑含氟聚合物，模制塑料，环氧树脂和塑料层压板的优异脱模剂。与油性脱模剂不同，当正确应用时，TraSys?428不会干扰后整理操作。TraSys?428预稀释后即可使用。适当的应用导致优异的脱模性，并且多次脱模是正常的。UsesTraSys? 428 is ideal for compression, transfer, and injection molding of organic rubber compounds, functioning in molding temperatures exceeding 193 °C (380 °F). TraSys? 428 also is ideal where part finish is critical, such as in the manufacture of O-rings and seals, It is not recommended for the molding of silicone elastomers.用途TraSys?428适用于有机橡胶复合物的压缩，转移和注塑成型，在超过193°C（380°F）的成型温度下运行。 TraSys?428也是零件精加工非常重要的理想选择，例如在O型圈和密封件的制造中。不推荐用于硅酮弹性体的成型。Directions for UseTraSys? 428 must be agitated before spraying.TraSys? 428 mold release coating should be sprayed on hot, clean, and dry surfaces. Properly applied, the coating will not be affected by water or most other materials that may come in contact with it.使用指南喷雾前必须搅拌TraSys?428。TraSys?428脱模剂应喷涂在热，干净，干燥的表面上。适当应用时，涂层不会受到水或可能与其接触的大多数其他材料的影响。Recommended Procedure1. Clean mold thoroughly, using glass or plastic bead media or high pH detergent, to remove all prior mold release and other sources of co