小知识：电梯电气维修常识(国外英文资料).docVIP

小知识：电梯电气维修常识(国外英文资料) Small knowledge: elevator electrical maintenance common sense The elevator door is on December 28 Safety circuit Function: To keep the elevator safe and safe, there are many safety features in the elevator. Only if every safety component is under normal condition, the elevator will run, otherwise the elevator will stop running. The safety circuit is a safety switch in the elevators security parts, connecting all the safety switches and controlling a safety relay. Only all the safety switches are connected and the elevator will be able to operate when the safety relay is hooked up. Common security loop switches are: Engine room: control screen stop switch, phase sequence relay, heat relay, speed limiter switch Shaft: under the limit switch, limit switch (some safety put the two switch circuit, others directly with the two switch control power supply) Ground pit: break the rope protection switch, ground pit repair box urgent stop switch, buffer switch Inside the car: the control box is on the switch Roof: safety window switch, safety clamp switch, car top repair box urgent stop switch Fault status: When the elevator is stopped, all the signals cannot be registered and the express train is unable to operate. First, the safety circuit fault is suspected. The state of the safety relay should be observed in the computer room control panel. If the safe relay is released, it should be judged as a fail-safe circuit. Failure possible causes: The phase sequence error or lack of the input power source causes the phase sequence relay action. The elevator is run or blocked for a long period of time, causing the action of the thermal relay. It is possible that the speed limiter is causing the speed limit switch. The top or bottom of the elevator causes the action of the limit switch. The ground pit breaks the switch action. It could be a speed limiter. Safety tongs. The reason should be found. Speeding may be the speed limiter action, speed limiter loss of oil