数控技师论文(原创)(国外英文资料).docVIP

数控技师论文(原创)(国外英文资料) The machining of the trapezoidal thread on CNC lathe Abstract: on the CNC lathe processing trapezoidal thread must have technical difficulty, especially in high speed cutting is harder, processing is not easy to observe and control, safety and reliability are poor. This requests us to trapezoidal thread processing method for continuous exploration. Keywords: trapezoid CNC turning machining method Trapezoidal thread than triangular thread pitch and tooth type, and high precision, smaller values of the two sides tooth type surface roughness, the trapezoidal thread turning, turning, feeding, fast cutting allowance, cutting resistance. This leads to a trapezoidal thread turning processing is difficult, after years of nc lathe practice teaching, through constant groping, summarize and perfect, for the trapezoidal thread turning also have certain cognitive, here is to explore the trapezoidal thread cutting method. The basic method of process analysis and processing of trapezoidal thread machining The dimension of the trapezoidal thread The code name of the trapezoidal thread is the Tr and the nominal diameter of the diameter of the thread, the unit is mm. The left screw is required to add ll to the dimension, and the right hand is not marked. For example, Tr36 by 6, Tr44 times 8l, etc. National standard regulations, metric trapezoidal thread tooth type Angle of 30 °. The shape of the trapezoidal thread is shown in figure 1, and the formulas for calculating the basic dimensions are 1 minus 1. Figure 1: the shape of a trapezoidal thread The name, codename and calculating formula of each section of the table 1-1 trapezoidal thread The name of the Code name A formula to calculate Tooth clearance item ac P 1.5 ~ 5 6 ~ 12 14 ~ 44 ac 0.25 0.5 one Large diameter D, D4 D = nominal diameter, D4 = d + ac Pitch diameter D2, d2, D2 = d-0.5 P, d2 = d2 trail D3, D1 D3 = d-2h3, D1 = d-p High tooth H3, H4, H3 = 0.5 p + ac, H4 = h3 8 teeth F, f F = f = 0.366, p The bott