数控车削中切削参数对外面质量的影响剖析(国外英文资料).docVIP

数控车削中切削参数对表面质量的影响分析(国外英文资料) Abstract: the choice of cutting parameters depends mainly on the level of the technologists, which is usually determined by the experience of the technical designers, and has some blindness. The choice of cutting parameters for aluminum alloy in CNC turning is carried out. Firstly, the experimental workpiece of 102 aluminum rod is processed on the CK6136 nc lathe for the parameters affecting the surface quality, and the experimental data is obtained, and the experimental data is analyzed. Secondly, the interaction effect of the main parameters is studied, and the selection method is summarized. Keywords: the surface quality of CNC turning parameters Taking a snapshot: when the machining accuracy and surface roughness of the parts are high, consider the appropriate precision. The machining allowance is generally smaller than that of ordinary car, usually 0.1 ~ 0.3 mm. In addition, according to the experimental data, the roughness value of the surface roughness is the same as that of Ral2.5. But when the machine tool stiffness is poor, the power is insufficient or the quantity is too large, it can be cut and processed many times, and the number of knives should be reduced gradually with the number of knives. When surface roughness is required for Ra1.0 ~ 1.6, a small amount of cutting is required to complete the finishing. The results show that the speed of the main shaft, the speed of the feed and the depth of the cutting depth on the surface quality of the machined workpiece are determined by the experimental data. At the same time, through the comparative analysis method, when the cutting material is aluminium alloy, the influence of cutting depth on surface processing quality is not significant, and the influence of feed rate on machining quality is significant. In the turning, the spindle speed and the speed of feed are generally used for reference, taking the main spindle speed n = 1200r/min, and the speed = 0.11mm/min. In the case o