斜拉桥三维仿真分析(国外英文资料).docVIP

斜拉桥三维仿真分析(国外英文资料) 1 / filname, cable - stayed bridge Keyw, pr_struc, 1 / prep7 ! Defining unit type Et, 1, beam4 Et, 2, link10 ! Define material properties Mp, ex, 1,3.5e10 Mp, 1,0.17 prxy, Mp, dens, 1250 Mp, ex, 2, 10 e15 Mp, prxy, 2, 0 Mp, dens, 2, 0 Mp, ex, 3,1.9e10 Mp, prxy, 3,0.25 Mp, dens, 3120 Mp, damp, 3,0.5 ! Define the real constant ! Define the real constant R, 1, 25.6, 5.546.133, 16 1.6 R, 2, 16, 29.417, 15.394, 3.4, 4.7 R, 3, 54,364.5, 162, 6, 9 R, 4, 40, 213.3, 83.3, 5, 8 R, 5, 1, 1/12, 1/12, 1 R, 6, 0.012, 0.012! The rope ! Create nodes and units ! Establish the main beam node / view, 1,1,1,1 / Angle, 1270, xm, 0 / replot * do, I, 1, 59! This loop is used to establish a semi-cross node of the main beam X = -174 * 2 + (I - 1) * 6! The leftmost x is 174 times 2, x equals 0, the left-hand side of x is equal to 6 Y1 = -14! The bridge is 28 meters wide, so the left-hand side is -14 Y2 is equal to 14 factorial. The bridge is 28 meters wide, so the right-hand side is 14 N, 3 times I minus 1 plus 1, x! Establish the main beam node 3 * (I - 1) + 1 for the node number N, 3 times I minus 1 plus 2, x, y1! The following two lines establish the nodes on both sides of the bridge N, 3 times I, x, y2! The absolute programmer who can come up with this modeling command is, haha * enddo! You can completely set up the three nodes in the end, and then use these three nodes to replicate 59 in the x direction, with a spacing of 6 ! Build the main beam unit The type, 1 Real, 1 Mat, 1 * do, I, 1, 1! The following circulation establishes the main girder unit of the bridge J is equal to 3 times I minus 1 plus 1 E, j, j + 3 * enddo ! Build a barbed beam The type, 1 Real, 5 Mat, 2 * do, I, 159,1! The following loops are used to establish the nodes of the bridges barbed beams J is equal to 3 times I minus 1 plus 1 J1 is 3 times I minus 1 plus 2 J2 = 3 * I E, j, j1 E, j, j2 * enddo ! Build a half-span tower I = 59 * 3! The variable is used to record the number of nodes in the bridge