胶印常见故障(国外英文资料).docVIP

胶印常见故障(国外英文资料) The big difference that identifies moisture, should see the page water first. This is the experience of the operator. Generally speaking, the water is big, the page reflects light, the side is brighter; On the other hand, the reflected light is weak and the side is darker. If the water is too large, it can be observed from the following points: (1) shovel ink on the ink roll with cardboard. (2) there are small beads of water on the skewers of water, and the ink roll in the ink rolls or the beads of water; (3) the water that has been shut down or shut down for a long time has not dried up. (4) the ink dot is empty and the ink is dull and dull. (5) there is a water shadow or water in the tip of the rubber roller. Control the water balance Ink and water are not absolutely incompatible. In the process of actual printing, ink and water are compressed by rubber rolls and rubber rolls, which combine to make the ink emulsified. There are two kinds of emulsification in ink: when the water is large, it forms water pack oil; When the water is small, the water is formed. Have learned, in the process of offset printing ink balance and mark the normal transfer, the accuracy of the depth of the inky, tinted, prints, such as dry and sticky dirty has a very close relationship. Generally speaking, the water is large, and the ink is made of ink. Small water, the blank section of the page will adhere to the ink and create a dirty trace. As a result, the ink and ink balance is the key to printing. Control the ink and ink balance In order to control the ink and ink balance, it is generally necessary to master the principle of water less ink. The lack of water refers to the premise that the blank section of the page is not viscous. Thick ink refers to the establishment of a proper amount of ink on the basis of little water. One of the most taboo things about printing is the big ink. When considering the amount of water, should see page graphic size and distribution, imprin