Zigbee发送数据流程图（国外英文资料）.doc

Zigbee发送数据流程图（国外英文资料） The Zigbee protocol reads the data from a serial port and sends it out to the roadmap Gi8AppStatus = IDLE_STATE; (MLMERXDisableRequest ()! = SUCCESS) {/ * Turn off the RX forever mode SOF MLMERXDisableRequest () function prototype in the media access layer UINT8 MLMERXDisableRequest (void) { PLMEDisableMC13192Timer1 (); / * * In case the timeout is being used, * disable it also * / If (IDLE_MODE) = = SUCCESS) {/ * * Attempt to * disable the * timer SOF * / PLMESetTrxStateRequest function prototype UINT8 PLMESetTrxStateRequest (UINT8 u8ReqMode) is in the physical layer { UINT16 u16Reg; RTXENDeAssert (); U16Reg = SPIDrvRead (MODE_ADDR); U16Reg = 0 xfff8; / * Clear mode. The switch (u8ReqMode) { Case IDLE_MODE: / * Write Idle * / # if defined (LNA) Mc13192_lna_off; # endif # if defined (PA) MC13192_PA_CTRL = PA_OFF; # endif U16Reg | = IDLE_MODE; Gu8RTxMode = IDLE_MODE; SPIDrvWrite (MODE_ADDR, u16Reg); Break; Case RX_MODE: / * Write RX * / # if defined (LNA) Mc13192_lna_on; # endif # if defined (PA) MC13192_PA_CTRL = PA_OFF; # endif If defined (ANTENNA_SWITCH) Mc13192_ant_ctrl_off; / Turn on the RX / / Mc13192_ant_ctrl_off; / Turn off the TX # endif Gu8RTxMode = RX_MODE; U16Reg, | = RX_MODE; SPIDrvWrite (MODE_ADDR, u16Reg); RTXENAssert (); Break; case RX_MODE_WTO:/ *编写RX，但是将gu8RTxMode设置为超时* / #如果定义(放大器) MC13192_LNA_CTRL = LNA_ON; # endif #如果定义(PA) MC13192_PA_CTRL = PA_OFF; # endif #如果定义(ANTENNA_SWITCH) 请打开RX天线* / / /关掉TX天线* / # endif gu8RTxMode = RX_MODE_WTO; u16Reg | = RX_MODE; SPIDrvWrite(MODE_ADDR u16Reg); RTXENAssert(); 打破; case TX_MODE:/ *写Tx。注意:force LO lock不使用* / #如果定义(PA) MC13192_PA_CTRL = PA_ON; # endif #如果定义(放大器) MC13192_LNA_CTRL = LNA_OFF; # endif #如果定义(ANTENNA_SWITCH)