单片机答辩相关（国外英文资料）.doc

单片机答辩相关（国外英文资料） The principle of single chip and the application of the answer sheet What should be done when the P0 is used for ordinary IO? A: pull up the resistance. How many ways of working in serial port? Where is the application? Answer: the main method of multimachine communication is 2 and 3. What is the source of interrupts? A: there are five. The wind is external interrupts 0, timer 0, external interrupt 1, timer 1, serial port. How many ways can a single chip interrupt trigger? What is the trigger? A: there are five. 1 high level trigger; Low level trigger; The rise along the trigger; The jump along the trigger; 5 the trigger. How many machines is the McS-51? A: its eight. Would you please draw a matrix keyboard for the scanning principle? A: the scanning principle: (1) line-by-line scanning. From the first line to the bottom line in turn signal low level, if the line is connected, if not press the keys, column line after the port is the 1 signal, if there is one key press, was not a 1 signal. (2) the line inversion method. The method is faster than the scan, but requires the line and line to be pulled on the hardware. Line line line as the output line first, column as the input line, the line output all the 0 signals, read the value of the column line in closed key column online value will be 0; Then the 0 signal is printed from the column line, and the input value of the line is read, and the line value of the closed key is 0. Thus, when a key is pressed, it must be able to read a pair of unique column values. And then this pair of rows can figure out where the closed bond is. How many kinds of digital tubes are there? The principle of how? Answer: there are two kinds, namely common cathodic and common anode. The common cathode is all the cathodes connected together, the common anode is to connect all the anode to VCC. How many ways to display a digital tube? What are the pros and cons? A: there are static and dynamic displays. Static can be stable whil