软件中断设置,优先级设置（国外英文资料）.docVIP

软件中断设置,优先级设置（国外英文资料） In software way more flexible setup AT89 series microcontroller interrupt priority level and implement a method of multilevel interrupt nesting 2010-02-21 these abstract: the paper introduces a method using a soft way flexible setting AT89 series single chip microcomputer interrupt priority level and realize the multilevel interrupt nesting method, analyzed the system of the solid. Keywords: singlechip; Interrupt priority; Interrupt nesting. Settings; When the solid 1 the introduction The AT89 series single chip microcomputer of ATMEL company is currently one of the most commonly used sex make us cheap MCU series, but the system resources are very limited, especially when the system to provide the interrupt priority. For example, the AT89 series of standard single-chip machines typically have two interrupt priority levels, which limits their application. Thus, the extension of interrupt priority and multi-level interrupt nesting becomes one of the most frequently considered issues in designing and developing single-chip movie theater systems. At present, people are mostly by increasing the specialized hardware and cooperate with the corresponding programming to solve this problem, obviously unfavorable to reduce the system cost, this way is flexible enough to use. The author the AT89 series standard microcontroller AT89C51 as the object, using pure software method, through in the initial part of the interrupt service routine to setup instructions in the interrupt before returning to the corresponding recovery instructions, successfully realizes the software of multilevel interrupt priority setting. At most, five interrupts are set at five interrupt priority levels. Five interrupt source of priority from high to low in turn is: the external interrupt INT0, timer/counter T0 interrupt INT1, external interrupt, timer/counter T1 interrupt and serial port interrupt. This also allows for a natural multi-level interrupt nesting. The principle and metho