ABAQUS错误提示信息(国外英文资料).doc

ABAQUS错误提示信息(国外英文资料) Q: Im wrong when running abaqus: ABAQUS error:the executable C:\abaqus\6.5-1\exec\standard.exe Aborted with system error access denied (error code 5) Answer: Look at the DAT and the MSG file has no warning or error, if not, there are three common reasons: Pre_memory abaqus_v6.env - parameter set too large - problems in user subroutine. Check the file in the INP user subroutine calls, whether using the correct parameters. You can try to use a simple example to debug user subroutine, to ensure the accuracy of. In addition to the user written subroutine, attention should be paid as much as possible to set some error. The bug - ABAQUS. You can try to remove unnecessary special settings in the model parameters, try to use the default value of ABAQUS. If the initial model is no problem, but the error message after modifying some parameters, can try one by one of these parameters will return to the initial state. -- -- -- -- -- -- Is not the software does not calculate? If you were a few analysis to see if.Dat and.Msg files, search error, look at the specific problem is what Grammar seems right In general, tie - binding constraints: the role is to model the two part area bound together, the two does not occur between the relative motion, the equivalent of welding together. If A and B are A binding, and B with node degree of freedom always exactly the same, this is the same effect with the coupling of ANSYS, ABAQUS in the surface and face binding is the degree of freedom coupling surface corresponding to the node. The definition of Tie master-slave surface, contact with similar, when stiffness, size, roughness of contradictions, the size and roughness. But the need for add and remove, but tie does not need this kind of operation, just before the start of the definition of a good step in the analysis, analysis of step does not make any action. In the MSG file if zero pivot InP is defined over constraints, but ABAQUS cannot automatically resolve the over