安川变频器(国外英文资料).docVIP

安川变频器(国外英文资料) The analysis and solution of YASKAWA G7 Yaskawa inverter fault G series inverter is widely used in Japan Yaskawa lifting control system, and made a lot of electrical manufacturers and users, who in many ports are used in the electric control system of Yaskawa inverter, early G5, along with the upgrading and development of the inverter, the inverter is now a lot of G7, and G5 has shut down exit so this paper is mainly on the market, mainly for G7 converter, G5 inverter can do for reference. Because of Yaskawa inverter the amount of G7, and in the process of long-term use will inevitably be the aging of the components, peripheral equipment installation and poor contact, affect the work of the external environment (including temperature, humidity, dust, vibration, Lei Dian), will cause the frequency converter fault. (I served in Guangdong, Guangdong, summer lightning, so deep feeling, thieves hate Thunder) Because many people have seen before written technical documents similar to my work, once again bring convenience, to express my heartfelt thanks to the previous, but has not seen a detailed and systematic articles, because I also work for some days, the Yaskawa is also quite familiar with, so I want to write an article detailed documentation, for the majority of friends to learn from each other exchanges, I hope to help you, I hope you correct criticism is not the right place for me to give; not perfect place to give complement; give improvement is not the best and most efficient method, truly achieve mutually beneficial purpose, thank you! (ha ha, first blown into the water) Say little and turn to the subject One, common fault articles (1) OC, Over, current overcurrent Description: the output current of the inverter exceeds the over current detection value. Common causes: 1, the inverter output side of the short circuit, grounding (motor burning, insulation degradation, cable damage caused by contact, grounding, etc.). 2 、 the load is too large and th