安装专业模拟试卷1有答案(国外英文资料).doc

安装专业模拟试卷1有答案(国外英文资料) 2003 installation professional simulation test paper One, one, one, one, one, one. The valve shall be installed on the ground by ___m. A, 1.5 B, 1.6 C, 1.2 D, 1.4 first choice answer: C The distance between the valve handwheel should not be less than ___m. A, 0.1 B, 0.08 C, 0.12 D, 0.15 Eliminating the stress and dehydrogenation produced during welding is done in ___. A, degrease B, pickling C, prefilm D, heat treatment, 3 The comfort air conditioning project is ___ for the humidity requirement. A, 30% ~ 60% B, 40% ~ 70% C, 50% ~ 80% D, 50% ~ 60%, the 4th choice answer: B 5, X-ray examination weld, the film used in the film is ___mm. A, 80 B, 50 C, 20 D, 40. 5 The boiler test run condition is running _C__ under full load. A, 1 day B, 2 days C, 3 days D, 1 week 6 choice answer: C The media used in the test of strength and tightness in general thermal pipes are ___. A, water B, steam C, air D, chlorine gas 7 The medium and low pressure lines are not strictly required, and the flange is ___. A, integral B, loose set C, threaded D, and other type 8 choices: B The elevation of outdoor drainage reinforced concrete in the design drawing is ___. A, the center B, the bottom of the tube, the outside D, the outer top 9, the answer to the answer: B X-ray examination of weld defects, and the thickness of the workpiece is higher than that of ___mm. Choice A, 40 B, 35 C, 30 D, 50 The binder for silica gel is __C_. A, coal tar B, epoxy resin C, water glass D, acid cement When a monomer is required to cooperate with the instrument operator, it shall be calculated according to the % % of the instrument installer. A, 30 B, 25 C, 20 D, 15, 12 When the pipe is laid out, the usual bending radius is not less than the multiple of the outside diameter is ___. A, 3 times B, 5 times C, 6 times D, 10 times 13, choice answer: C In production automation, the function of the MIS layer is _C__. , achieve the best production control B, in accordance with the requirements of pr