建筑结构作业(国外英文资料).docVIP

建筑结构作业(国外英文资料) Construction work 1 Note: this work includes the first chapter of steel and concrete, physical and mechanical properties of the second chapter of the concrete structure the basic calculation principle, the third chapter flexural bearing capacity calculation of the content, please complete in four weeks ago. First, fill in the blanks (2 points per day, a total of 20 points) 1. for the obvious reinforced flow amplitude (commonly known as mild steel), general (yield strength) as the basis of the design strength of steel. 2. the concrete strength grade is represented by the symbol C on behalf of (concrete), and the figure following the C represents the cube compressive strength standard in () units. 3., the limit state of the structure (bearing capacity limit state) and (the normal use limit state) two kinds. 4. the strength design value of concrete and reinforcement is defined as the strength standard value divided by the corresponding material strength partial factor. The vertical distance from the outer edge of the 5. (longitudinal force steel bar) to the surface of the concrete is called the thickness of the concrete protective layer, expressed in C 6, reinforced concrete from the loading to the destruction of the component, there are three stages of the force of the beam, respectively, the stage of elastic work, (with cracks work stage) and (destruction stage) stage. 7, the tensile steel bar first reaches the yield, then the concrete compression failure of the beam, known as the (reinforced) beam, this damage is known as (ductile) damage. 8. The main factors affecting the failure modes of diagonal section with stirrups are shear span ratio and stirrup ratio. 9 、 in the three forms of the oblique section destruction of reinforced concrete beam, only the (shear pressure) damage is the basis of the calculation of the bearing capacity of the oblique section. 10 and T section beams are divided into two kinds according to the location of the neutral axis.