材料检测员知识点(国外英文资料).docVIP

材料检测员知识点(国外英文资料) Asphalt (a), fill in 1. asphalt mixture design method is mainly composed of (mix), (production mix), (production mix verification) 3. adopted in our country (void ratio), (saturation), and (residual stability) and other indicators to characterize the durability of asphalt mixture material. 4. asphalt mixture according to the nominal maximum particle size, can be divided into coarse, medium, fine, sand and other categories. 5. the strength of asphalt mixture (mainly depends on the shear strength (resistance) and deformation of two) to determine the problem 1. asphalt pavement construction, if the mixed material heating temperature is too high or too low, easy to cause the asphalt pavement bleeding. (x) 2. asphalt mixture, coarse aggregate refers to the particle size of more than 2.36 of the crushed stone, broken gravel, etc.. (V) 3.SMA high asphalt content, in order to prevent the construction of asphalt mixture should deviate from the stabilizer into fiber mixture into the. (V) 4. Marshall stability test at higher temperature is more stability, flow value is small (5. x) asphalt mixture aggregate for screening using dry sieving. (* three), the main technical indexes of asphalt mixture is 1. (ABCD) A. B high temperature stability and low temperature cracking resistance and durability of C D, the anti slide test pavement of asphalt paving is 2. (A) A. B, construction preparation stage of asphalt mixture paving asphalt compaction, C, D mixture of asphalt mixture between transport 3. asphalt concrete and asphalt macadam is A. A. The residual porosity after compaction is different from B. The dosage of mineral powder is different from C. The maximum particle size of aggregate is different from D. The ratio of asphalt to stone is different. The size of the coarse aggregate and fine aggregate for the 4. asphalt mixture is B. A,.1.18mm, B,.2.36mm, C,.4.75mm, D,.5mm 5. D rutting test to test the performance of asphalt mixture. A. B. C. The deformation crack