汽车制造与装配技术毕业论文(国外英文资料).docVIP

汽车制造与装配技术毕业论文(国外英文资料) Automobile manufacture and assembly technology paper topics: elantra common electronic engine control system fault diagnosis and maintenance system dont automotive engineering specialized industry manufacturing and assembly technology, the purpose of this research is elantra detection and fault diagnosis knowledge of electronic engine control system, this paper introduces the overview of automobile engine electronic control system and elantra engine electronic control system fault diagnosis knowledge, elantra engine electronic equipment fault diagnosis, elantra engine electronic control system maintenance and elantra engine electronic control system for the maintenance of common failures, etc. On engine electronic control system are introduced in the introduction to the electronic control ignition device (ESA), electronic fuel injection system (EFI), exhaust gas recirculation (EGR), idle speed control (ISC), valve timing control system, secondary air injection, oil and gas evaporation control, etc., discusses the composition, working principle and function of them. Basic knowledge in the fault diagnosis diagnosis of electronic control system are introduced in the chapter precautions, common tools and instruments, commonly used fault diagnosis and maintenance of the general procedure and basic methods. This paper introduces the characteristics of automobile circuit and electronic equipment in the fault diagnosis section of electronic equipment and the main points of troubleshooting. In the fifth chapter introduces the engine electronic control system maintenance, maintenance methods, discussed the system steps, and the matters needing attention, etc., and attached a picture flow charts and tables. In the last chapter introduces the electric control system common fault diagnosis and maintenance, and lists some common maintenance case, this paper discusses the failure phenomenon, the possible causes and troubleshooting methods. The characteristics