甲基丙烯酸的开车方案(国外英文资料).docVIP

甲基丙烯酸的开车方案(国外英文资料) At the same time, open the C220 tower bottom valve LV2202 will go through the methanol water solution E-310 (C-220 MOH 2201-65, vice line M1B - LV2202 - MOH 2202-65 M1B, MOH 2203-65 M1B, MOH 3105-65 M1B-PP, MOH 3106-65 M1B, V-320 V320) directly into the tank, gradually establish hexane and methanol aqueous solution interface; At this point, the instrument personnel must be in place in time, as soon as possible to adjust the good system, and use. (2) the establishment of C-230, liquid level tower and reflux tank: P-221 activated by V231 to start line into the hexane reflux tank V-231 to establish a certain level, P232 will start C-230 reflux pump hexane into the C-230 tower, built the tower bottom liquid level; (3) the liquid level of C-240 tower and reflux tank is established: firstly, the purchased MMA is pumped into the tank and measuring tank, and then the MMA is pressed to the reflux tank V241 of C-240 tower with nitrogen to establish the liquid level. Start the C-240 reflux pump P242A/B, MMA the C-240 in the reflux tank into the inhibitor tank, and put the inhibitor powder into the V261. After stirring, the preparation is finished and then into the lower layer of the inhibitor tank; MMA into the C-240 tower, the establishment of tower tank level, at the same time, start metering pump P-261, will be equipped with a good inhibitor liquid into the C-240 tower at the top of the reflux pipeline, the tower, column internals and reflux pipeline infiltration. (4) level establishment of C-250 tower and reflux tank: through the unqualified material pipeline, use nitrogen to press the MMA in the metering tank to the backflow tank V-251 of C-250 tower, and establish the liquid level; Start the C-250 reflux pump P253, drive the MMA in the reflux tank V-251 into the inhibitor tank, and put the inhibitor powder into the V-262. After mixing, it can be sent into the lower layer of the inhibitor tank; V-251 into the C-250 tower MMA, the establishment of tower