五液压辅助元件.pptVIP

第五章 液压辅助元件;第一节 管路和管接头;1、管路种类;2、管径（内径）的确定;常用管接头种类：;（3）扩口管接头（只适用于薄壁铜管，工作压力≦8MPa的场合）（硬管）;第二节 油箱;三、油箱设计时的注意事项; 3、吸油管和回油管应尽量相距远些 管端宜斜切45°，以增大通流面积，降低流速，回油管斜切口应面向箱壁。;第三节 过滤器;二、过滤器型式;三、过滤器的选用和安装;第四节 密封装置;一、对密封装置的要求;二、密封装置的类型和特点：;2、O型密封圈 外形;3、唇形密封件;4、组合式密封圈装置（二个以上元件组成）;第五节 蓄能器;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;卡套管接头;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.; a）网式 b）线隙式;深度型过滤器;中间型过滤器;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;压缩率W=[(d0-h)/d0]X100%，对于固定密封、往复运动密封和回转运动密封，应分别达到15~20%、10~20%和5~10%。;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;图5-13 小Y形密封圈（唇形密封圈）;Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd.;a）;主要用作液压泵、液压马达和回转式液压缸的伸出轴的密封;充气式蓄能器