CISCO网络设备配置实训.pptVIP

CISCO网络设备配置实训 网络构建技术专业（2）班陈同 查看设置的命令 Show interface Show vertion Show terminal Show history Show ip interface Show ip interface brief Show controllers s0 Show interface Show version Show terminal Show history/show ip interface brief Show ip interface Show controllers s0 实验二 路由器维护设置 Cdp telnet Tftp 密码恢复 CDP telnet Tftp 密码恢复 1.重启,按ctr+break 2.进入Rom监视模式,在提示符下输入0显示配置寄存器值 3.O/R 0X2142 4.I,重新初始化 5.NO,进入路由器模式下 copy start run 6.修改密码,配置寄存器值 7.copy run start 实验三 路由器协议RIP、IGRP静态路由配置与维护 IGRP Configuration Example IGRP Displaying the IP Routing Table EIGRP 支持不同的网络拓扑 Configuring OSPF on Internal Routers show ip ospf interface 标准访问列表举例 1 查看访问列表 VLAN　VTP配置的步骤 配置ISDN BRI ip address negotiated ip nat outside no ip directed-broadcast encapsulation ppp dialer idle-timeout 5000 dialer string 163 dialer-group 1 isdn switch-type basic-net3 ppp authentication pap callin ppp pap sent-username 663 password 663 ip route BRI0 dialer-list 1 protocol ip permit 查看 Frame Relay 信息 查看 Frame Relay 信息 显示 LMI 信息 查看 Frame Relay 信息 显示 PVC 数据通讯信息 查看 Frame Relay 信息 显示路由信息 查看 Frame Relay 信息 wg_ro_a#show ip int e0 Ethernet0 is up, line protocol is up Internet address is 1/24 Broadcast address is 55 Address determined by setup command MTU is 1500 bytes Helper address is not set Directed broadcast forwarding is disabled Outgoing access list is not set Inbound access list is 1 Proxy ARP is enabled Security level is default Split horizon is enabled ICMP redirects are always sent ICMP unreachables are always sent ICMP mask replies are never sent IP fast switching is enabled IP fast switching on the same interface is disabled IP Feature Fast switching turbo vector IP multicast fast switching is enabled IP multicast distributed fast switching is disabled text ommitted 启用VTP 启用主干功能,以支持VLAN间的路由功能 创建VLAN 将端口加入VLAN 配置PPP协议 配置ISDN实现广域网通信 帧中继 显示协议、DLCI、和 LMI 的相关信息 Router#show interface s0 Serial0 is up, line protocol is up Hardware is HD64570 Internet addres