SPI抛光规范.docVIP

SPI抛光规范(SPI A1-SPI D3) 上一篇 / 下一篇 ?2007-10-23 19:26:24 / 个人分类：模具知識 查看( 93 ) / 评论( 1 ) / 评分( 0 / 0 ) An SPI A-1 Diamond Finish is a specialty of Bales Mold Service. We use it to produce the finest finish on molds, producing highly visible or lens quality parts. The SPI A-2 is the most widely used diamond finish, providing good release and good visual parts. An SPI A-3 is a fine choice for release where a high gloss appearance is not required. All diamond finishes work well with chrome and nickel. ? Paper Finishes, SPI B-1 to B-3 – Next to diamond polishing, paper finishes are the second most refined finishes available. Paper finishes produce a slightly reflective or glossy shine and very good release. They are often recommended for products that do not require a big decorative or visual impact. ? Stone Finishes, SPI C-1 to C-3 – The most economical finish, stone finishes are also the first step in the process of creating both the paper and diamond finishes. Stone finishes provide good release but very little gloss to the plastic part. This is a good choice for strictly functional molded parts where aesthetics are of no importance. ? Blast Finishes, SPI D-1 to D-3 – When done properly, blasted finishes can produce some of the most interesting stipples and textures on mold surfaces. From a fine satin texture with varied degrees of gloss to a flat, no-gloss coarse stipple, Bales has the blast media to produce the proper finish for you. Blast finishes are also an excellent way to camouflage weld repairs and slight imperfections. ? Specifications Types ofFinishes Current SPIFinish Numbers Descrīption andPrevious Finish Numbers Roughness Comparison R.A. Diamond #3 Diamond Buff A1 is comparable to #1 0-1 #6 Diamond Buff A2 is slightly finer than #2 1-2 #15 Diamond Buff A3 has more imperfections than 2-3 Paper 600 Grit B1 is finer than #3 2-3 400 Grit B2 is slightly finer than 4-5 320 Grit B3 is comparable to 9-10 Stone 600 Stone C1 is finer than