fanuc配置设置(国外英文资料).docVIP

fanuc配置设置(国外英文资料) Set the match parameters according to the machine tool configuration Settings Set the direction of each axis and the rapid movement speed NO1410 # empty running speed; NO1420 # axis fast moving speed; NO1421 # fast moving speed ratio F0; NO1423 # is the speed of the JOG feed; NO1424 # manual fast movement speed; NO1425 # returns the FL speed at reference point; The NO1428 # axis returns the reference point velocity; NO1430 # Max cut into speed. Cannot take place worldwide feed: check parameters NO1423 # worldwide attention of every axis feed speed, through NO1402 # parameters (0: choose feed per minute; 1: turn each feed) to choose whether to use this function, at the same time check whether cable between the main shaft position coder and CNC wire break or ground. Set the time constant for the speed of each axis NO1610 # 0 = 1 is a drag after the interpolation; NO1610 # 4 to slow down the same exponential as the cut. NO1620 # fast moving straight line + deceleration time constant; NO1622 # cut into the reduced time constant; NO1623 # is cut into the speed of the deceleration. NO1624 # JOG is added to the speed of slow down. NO1625 # JOG to the exponential function of the speed of the deceleration. Set the position width of each shaft and the setting of the rotation direction of the motor The width of each axis of NO1826 #; The rotating direction of NO2022 # motor is 111: forward; - 111: the reverse. Set the limit of position deviation for each axis movement and stop NO1828 # (#) : the position deviation limit in the axis movement; NO1829 # stop the limit value of position deviation; Set each axis zero drift and handwheel function NO8131 # does not use the handwheel to zero: 1: using. The moving direction of each axis in the rotation direction of the NO7102 # 0: is the same direction; 1: be the opposite direction. NO7113 #, NO7114 # handwheel in to the multiplier. Check the limit of each shaft, set the speed of the return zero of each axis and the