ZB206多功能电池容量测试仪使用说明书V1.2版本ZB206+(国外英文资料).docVIP

ZB206多功能电池容量测试仪使用说明书V1.2版本ZB206+(国外英文资料) Quick hand instructions (by default) : The battery charged by the test battery (or the USB output of the charger) is connected to the blue terminals BAT + and BAT - the cables are as short as possible! The tester is dc 12V Voltage (the micro USB power is connected to 5V USB power supply), the tester is turned on to display the default current. 2. S - or S++ buttons can within the scope of 0.1 to 2.6 A, change the preset current, right after the press about the SK button to begin testing (such as the failure code behind the Err * please refer to the content), the tester The smart select battery type and set the termination voltage, the RUN lamp is lit, and the digital tube display values will be shown from the capacity Ah, the energy Wh, voltage V, and current A. After the test, RUN The lights go out, showing a quick flicker on Ah and a sound reminder. After completion of 3. Press the button SK tester stop flashing alarm, press the S - or S++ button switch to check the capacity of the battery Ah, energy Wh and discharge voltage V platform, when again Press the SK button, the tester is returned to the boot state, and can repeat the previous operation to test the next battery. Note: after the test must be a key operation, the backup data can be removed, otherwise the backup results will always save, even if the power will not clear! Error code Err * meaning and processing: Err1: the battery voltage is too high. Please confirm that the voltage under the battery test is below 8.5 V. Err2: the battery voltage is too low (below the set termination voltage), please confirm the battery voltage and reset the battery, which also displays Err2. Err3: the battery does not support a set of current or circuit resistance too large. Use a smaller current test and ensure that the line is thick and short, and the electrodes are in good contact. Err4: power pipe damage, which normally occurs after bad modification, can replace the power pipe by