自动挡车驾驶技巧(国外英文资料).docVIP

自动挡车驾驶技巧(国外英文资料) One, automatic stop driving procedure: Start the engine; The gearbar only starts the engine in the P and N gear. Cars under stationary state or body after less than 5 km/h, choose before exercise gear must step the brake pedal, and hold down the shift lock button, can move the shift lever from P or N stall out. Its worth noting that even at the idle speed, the driving force is not completely interrupted, and the car can still be slightly exercised. 2, start; After the engine starting, step the brake pedal, press the shift lever lock button, will shift lever hangs in exercise gear, loosen the hand brake, then slowly loosen the brake pedal, the car can drive slowly, in the back or brake cant immediately while backing up, pay attention to control the speed of the car. 3, travel; 1) switch in different directions depending on the road and speed. ) 2 D file is the most commonly used driving gear, cars can be in 1 ~ 4 gear automatic transmission, automatic transmission is based on the throttle size and speed to determine the speed, in alleviating or normal tread down the accelerator pedal, the automatic transmission will be early in high-grade, and later in low, according to a more fuel-efficient procedure to adjust the speed of the car. If you step down the gas pedal quickly and force a lower gear to be switched on, it will be late and fast, and keep the engine at a high power. 3) drive, if carelessly in N, before the change into the forward driving gear again must lift the gas pedal, and can be carried out until the engine idle speed running shift, should avoid to use N gear at high speed to taxi. 4) lower slope: no N gear is used when downhill. Downhill should according to the gradient in low bit, in order to make full use of engine speed traction control the speed of the car, from D in low-grade, should first braking deceleration to adapted to the low again when the speed of the gear shift, 5) rain fog and other bad weather conditions, the road is sl