FST35S00C触摸屏_编程指导_v111.pdf

Projected Capacitive Touch Controller - FST35S00C Specification and Programming Guide - v1.10 Section 1. General Description This proj ected capacitive touch controller (FST35S00C) is designed for small scale touch panel applications in portable dev ices. The system block diagram is as shown in Fig. 1. FST35S00C has up to 22 channels to connect the touch screen and three communication pins 2 connected between CPU and FST35S00C, which are including external interrupt INT, I C pins SCL and SDA. The INT is active low while the touch state is calculated by FST35S00C and the 2 touch information can be translated via I C communication interface. The 2 FST35S00C specifications are as shown in Table 1. The I C data format, protocol, report packet and sample code are described as following. Table 1. FST35S00C specifications Notice: 1. This documentation is preliminary specification. So the detail specification may be changed without any notice. 2. NDA Confidential. Do Not Distribute Packaging Dimension Section 2. Communication Interface Pin Assignments and Definitions 2 I C Data format Report rate = 1 / TINT , it depends on properties of touch screen such as resistive value, channel number, thickness and material of cover lens, etc. Protocol Read mode: Master-receiver, slave-transmitter. Write mode: Master-transmitter, slave-receiver. Section 3. Report Packet Single Touch Each report packet contains 6 bytes. The single touch packet format is as follows: Status: indicates the touch status: 1 for touch down and 0 for touch up. A10- A0