模具设计流程(国外英语资料).doc

模具设计流程(国外英语资料) Analysis and digestion of plastic products and samples. Geometry of 1. products; 2. dimensions, tolerances and design criteria for products; 3. technical requirements (ie technical conditions) of the products; Appearance requirements of 4. products; Two. Determine the model of the injection machine. Three. The determination of the number of cavities and the arrangement of cavities, such as: 1. the weight of the product and the amount of injection of the injection machine. Accuracy of 2. products. 3. products have side core pulling and treatment methods, etc.. Four. Selection of mould steel. Five. Determination of parting surface. 1. does not affect the appearance of the product requirements. 2., to ensure the accuracy of products. 3. is advantageous to the mold processing, especially the mold cavity processing. Six. Determination of parting and core pulling mechanism. Seven. Determination of formwork and selection of standard parts. Eight. Design of gating system. Nine. Design of exhaust system. Ten. Design of cooling system. Eleven. Design of thimble system. Twelve. Design of guiding device. Thirteen. Drawing the main parts of the mold. Fourteen. Proofreading of design drawings. Fifteen. Design drawings countersigned. Die design steps -------------------------------------------------------------------------------- I. accepting the assignment The task book for forming plastic parts is usually proposed by the designers of the parts: The formal system after signing the product drawings, and indicate the use of plastic trademark, transparency. The plastic product specifications and technical requirements. The production yield. The plastic sample. Usually, the die design task book is made up of the plastic parts and technicians according to the task book of the molding plastic parts. The mould designer designs the mold on the basis of the plastic plastic parts task book and the die design task book. Two collect, analyze and digest the original data Colle