电路板设计步骤(国外英语资料).docVIP

电路板设计步骤(国外英语资料) First, the preparation of the circuit board design 1. Draw the schematic diagram and generate the corresponding network table. With the network table, the design of schematic diagram can not be carried out directly into the PCB design system. 2, manually change the network table, some components of fixed, feet, and other principles on the pad not defined on the network connected to it. Some schematic and PCB package library pin name inconsistent device pin name and PCB package library consistent, especially two, transistor and so on. Two, draw their own definition of non-standard components of the packaging Library It is recommended to put all of the components you have painted into a proprietary design file for your own PCB library. Three, set up PCB design environment and draw the printed circuit frame, including the middle of the hollow and so on. 1, the first step after entering the PCB system is to set up the PCB design environment, including setting the grid size and type, cursor type, layer parameters, routing parameters, and so on. Most of the parameters can be used by the system default values, and after these parameters are set, in line with personal habits, and then no need to modify. 2, planning circuit version, mainly to determine the circuit board frame, including the size of the circuit board and so on. Place suitable sized pads in place where holes are to be placed. For 3mm screws, the outer diameter of the 6.5~8mm and the inner diameter of the 3.2~3.5mm can be used as pads. Four, open all the PCB library files that need to be used, then transfer to the network table file and modify the part package This step is a very important link, the network table is the soul of PCB automatic routing, and also the interface between schematic design and circuit version design. Only after the network table is loaded can the wiring of the circuit board be carried out. In the schematic design, the package of parts may be forgotten, but when the netw