东芝166(国外英语资料).doc

东芝166 Toshiba 163 small wrench how to do? 0+8 boot to 400 start to 0 to insert + shut down to boot. Wrench can work properly, press the C key and the 8 button to see what the code does not reflect, it should seriously consider whether your machine is due to other reasons Correct steps: 1: hold down the 0+8 key, not loose, such as the screen line, AD is letting go 2: enter 251, this is the screen will show 72 (this is because 163 is a small screen, the same screen can only display 3 values, in fact, there are 3 0 behind, you can press 200%, this button will be able to see the latter 3) 3: connect, press 9 0, and then press the insert key 4: turn off the switch, the small wrench disappeared The value of 5:252 is not recommended for you to change Code： 15-- photo 154% exposure adjustment - range: 0~255, default value =128 16-- photo 50% exposure adjustment - range: 0~255, default value =128 17-- photo 200% exposure adjustment range: 0~255, default value =128C1--, main motor lock The C21-- optical system failed to complete the initialization and the optical system was locked C26-- exposure lamp burned out C32-- out of the box (UA) TD sensor automatic adjustment failed When the C41-- power is on, fix the thermistor, or fix the lamp open C43-- fix the thermistor exception during the warm-up or after the warm-up is completed C44-- fix the lights during the warm-up or after the warm-up is complete C54-- pager - communication error with primary CPU C55-- automatic copy machine ADF- and main CPU communication error C71--ADF main motor lock C72-- bad adjustment detected by the position sensor C73--EEPROM initialization bad C81-- paging paper motor abnormal C82-- pager bucket shift motor abnormal C83-- pager limit error C84-- pager limit error C85-- pager in situ sensor error C86-- pager displacement sensor error C94-- in AJ (CH) mode, the optical system failed to complete the initialization, and the optical system locked the cardboard in the E1-- machine E2-- fixing near