供油提早角的检查与调剂(国外英语资料).doc

供油提前角的检查与调整 Intellectual, zizhizhe ming. The waves between the river and the sky surge into the wind and the earth. Xiaolou night listening to the storm, energy-saving. Truthfulness east side, always a riot of colour of spring. Anteriormo Chou no friends, everyone knows you in the world. Inspection and adjustment of fuel supply advance angle Source: kuny group published: 2010-2-6 has been viewed 496 times -------------------------------------------------------------------------------- Characteristics of timing inaccuracy of diesel engine oil supply First, the oil supply time is too early. The diesel engine is not easy to start, the crankshaft is easy to reverse, and in the work, the cylinder will produce a sharp knock, and even cause early wear of the parts, power reduction, idle bad. When judged by low speed to high speed, rapid increase of accelerator pedal test, such as the accelerator pedal more urgent, increase the more serious abnormal sound, speed increased after noise reduced or disappeared, quickly recover the accelerator pedal when the sound disappears, and the sound speed is reduced after recovery, for the fuel injection time too early; Two is the oil delivery time too late. Easy to cause the cooling water tank, engine overheat boiling, diesel consumption increased; with the increase of the accelerator pedal speed cannot be increased quickly, the exhaust white smoke, economy and power, in case of the above phenomenon can be determined for the time too late. Inspection of fuel advance angle The first fuel injection pump cylinder high-pressure tubing removed, the engine decompression decompression to handle position, fuel injection pump at maximum throttle position, to the exclusion of diesel in the pipeline air supply system, so that it is full of diesel. Turn the crankshaft so that the first cylinder piston is at the compression TDC (both inlet and exhaust doors are closed), at this time the mark on the flywheel or pulley shall be aligned to the mark on