压力(真空)表的检定(国外英语资料).doc

压力(真空)表的检定 1. purpose Guide and regulate the calibration personnel to correctly perform the verification and repair work of the pressure (vacuum) meter. 2. scope of application It is applicable to the verification and repair of the pressure (vacuum) meter issued by the verification staff in this station (station). 3. personnel requirements The operator shall be a metrological inspector who has high school education or above and has been qualified by the metrological management department at the higher level and has obtained the general pressure meter and the certificate of measurement certificate. 4. tools and measuring tools Should be equipped with not less than the test pressure gauge measuring range 0.4 Bourdon tube precise pressure gauge and vacuum gauge set or two sets as a standard table, and pressure calibrator (including water separator), equipment of vacuum calibrator, and the testing and repair required needle, screwdriver, scissors, seal clamp and seals, gasoline, cotton supplies. 5. operation procedure 5.1 preparation 5.1.1 checks the meter scale according to the range of the selected meter, and checks the meter label for validity if the meter is larger than its range. 5.1.2 will be detected and the standard table table installed on the tester, the seized table if oxygen, acetylene no oil, it should be installed in the oil joint is connected with the oil-water separator, check and adjust the calibrator, remove oil in the air, so that each part of a good role. 5.1.3 observation test of temperature and humidity, temperature and humidity to see whether the verification regulation requirements, namely temperature (20 + 5) C, relative humidity is less than 85%, otherwise, should be regulated to meet the requirement. The measured values of temperature and humidity should be filled in the verification record of the pressure gauge. 5.2 calibration and repair 5.2.1 visual inspection: the appearance, eyesight observation marks, reading part, dial content should c