机械类资料(国外英语资料).docVIP

机械类资料 Dry machinery design of this line of entry and indispensable information 1. sleeve type parts This kind of parts usually have a shaft, bushing and other parts, in view of expression, just draw a basic view plus appropriate sections and dimensions, you can put its main shape characteristics and local structure express. In order to facilitate the processing of the picture, the axis is generally placed in horizontal projection, it is best to choose the axis as the side of the vertical position. When marking the dimensions of sleeve type parts, the axis is often used as the radial dimension reference. The system shown in Figure 14, with the diameter of 11 (see section A-A). In this way, the design requirements and processing process standards (shaft parts in the lathe processing, both ends with a thimble to withstand the center of the shaft hole) unified. The length of the benchmark, often choose the important end face, contact surface (shoulder axis) or processing surface. As shown in the figure of the surface roughness is Ra6.3 of the right shoulder, the main dimension benchmark was chosen as the direction of the length of the 13, 28, 1.5 and outjection 26.5 dimensions; then based on the auxiliary shaft end for the right length, which marked the axis length of 96. 2. sets of cover parts The basic shape of this kind of parts is disc flat, generally end cover, valve cover, gear and other parts of the main structure, they generally have a revolving body, the local structure often with various shapes, uniform hole and flange rib etc.. In view of the selection, the general selection section view of symmetry or the axis of rotation as the main view, also need to add other appropriate views (such as the left view and right view or view) the shape of the parts and uniform expression structure. As shown, a left view is added to represent rounded square flanges and four evenly through holes. When marking the dimensions of the cover and cover parts, the axis of the axle ho