汽车冷车难启动(国外英语资料).doc

汽车冷车难启动 Special reasons for cold car starting difficult 2011-08-02 15:50:47 source: Author: [big and small] browse: 307 comments: 0 The special cause of cold start difficult this is an original Buick 3, because maintenance is difficult to start in a friends garage, but 1 weeks later period still does not solve the problem, in solving the actual process is not found fault with the complexity of diagnosis, but the ideas into the misunderstanding. The symptom of this cars failure is this: if the car starts successfully once at the start, then the car starts smoothly in all cases of the day. Sometimes, however, if a startup problem occurs, it is very difficult to start the engine in the next boot operation. Sometimes the batterys energy is exhausted and it doesnt start successfully. Good times, bad times, sometimes a few days, and sometimes a continuous occurrence. When the boot is difficult, the engine can operate at a normal starting speed under the pull of the starter. After I took over the car, it was safe all morning and there was no trouble in our uninterrupted experiments. The engine was running smoothly, accelerating, responsive, and powerful, and even then I didnt believe what a good car would be like. In the process, I have carefully examined all the areas that can affect the difficulty of starting a cold car. Theres nothing wrong with it. After eating lunch, ready to drive to the side of the workshop when the failure occurred, and friends say the same, the engine in the engine to drag the stem to dry, that is, not to the car. Since all the equipment has not been removed, check the fuel pressure meter immediately, and 325KPa, which is in the process of starting the test, so that the pressure must be all right. The injection pulse width TECH2 display engine at startup is 2.5ms, think that TECH2 is only through the injection pulse width data calculated, and checked by the test lamp the actual working conditions of the injector were normal, can hear the sound o