用命令启动控制面板和使用RUNDLL32大全(国外英语资料).docVIP

用命令启动控制面板和使用RUNDLL32大全 Start the control panel with commands and use the RUNDLL32 Encyclopedia Start the control panel with commands and use the RUNDLL32 Encyclopedia There are two ways to run the control panel module, CPL The first is by means of RUNDLL or RUNDLL32 Running rundll32.exe shell32.dll, the Control_RunDLL program brings up the control panel window Syntax: Run (RUNDLL32, SHELL32.DLL, Control_RunDLL, filename.CPL, @n, t) Filename.CPL various modules in the control panel CPL N in the various modules CPL in the attribute category, default to 0 or empty, but the comma can not be saved T every few pages in each category Such as: Run (rundll32.exe, shell32.dll, Control_RunDLL, main.cpl, @0) Run (rundll32.exe, shell32.dll, Control_RunDLL, main.cpl, @1) Results: the first line displays the mouse property, and the second line is the keyboard attribute. The mouse and keyboard attributes belong to the main module Run (rundll32.exe, shell32.dll, Control_RunDLL, desk.cpl, 1) Run (rundll32.exe, shell32.dll, Control_RunDLL, desk.cpl, 4) Results: the first action displays the propertys screen saver page, and the second behavior displays the settings page of the property. In addition, there is only one display property in the desk.cpl module, so it doesnt matter if you dont add @0. Second methods: Running the control.exe program brings up the control panel window Syntax: run (CONTROL.EXE, filename.CPL, @n, t), the parameter is the same as the first method Such as: Run (CONTROL.EXE main.cpl @0) Run (CONTROL.EXE main.cpl @1) Run (CONTROL.EXE desk.cpl, 1) Run (CONTROL.EXE desk.cpl, 4) The following modules for the control panel (the operating system is not the same, may not be the same, you can use @n and t to try, using WinXP prevail, different departments can find different CPL files on the inside and outside): System properties Sysdm.cpl (routine / computer name / hardware / restore, etc.) Add / Remove Programs Appwiz.cpl (add program / change delete program / add delet