半钢轮胎制造理论培训.ppt

12 混有杂质的胶料必须与其他的正常胶料分开放置。 13 防止墙皮及房屋漏雨的雨水污染产品。 14 如在机台上处理产品中污染物 时必须将塑料隔离垫布等污染物处 理干净，如无法处理干净必须用黄 蜡笔画上，并在生产小票上进行标 注。 16 如果复合后的产品不合格 必须将两种或两种以上的产品 彻底剥离开且要分别放在各自 指定的位置。 各岗位工作方法 裁断系列设备 * NC CUTTERCOMPLEX * LP CUTTER * SLITTER * GI/LP COMPLEX BAZ 撕条机 TORN BAZ CX3制造机组 TPFR TP EXTRUDER BT/TP COMPLEX RD/ BT/TP COMPLEX FE/PT复合机 FE/PT COMPLEX My specification我的施工表 Identification of my incoming product来料标识 Consistent between spec and ID? 施工表和标识一致吗？ WE HAVE SAID THAT IT IS IMPORTANT TO HAVE THE CORRECT QUALITY CALANDRAGE BEWEEN THE CORDS, S THAT IT IS ABLE TO WITHSTAND THE SHEARED. WHAT CAN HAPPEN DURING OUR MANUFACTURING PROCESS WHICH HAS AN EVEN MORE DETRIMENTAL EFFECT THAN USING THE WRONG NAPPE CARCASSE QUALITY. HAS ANYONE HEARD THE TERM FLUAGE? WHAT IS IT? TALK THROUGH SLIDE BUILD. HOW CAN WE PREVENT FLUAGE? USE AN RFI, BETWEEN THE GI AND NC. WE HAVE SAID THAT IT IS IMPORTANT TO HAVE THE CORRECT QUALITY CALANDRAGE BEWEEN THE CORDS, S THAT IT IS ABLE TO WITHSTAND THE SHEARED. WHAT CAN HAPPEN DURING OUR MANUFACTURING PROCESS WHICH HAS AN EVEN MORE DETRIMENTAL EFFECT THAN USING THE WRONG NAPPE CARCASSE QUALITY. HAS ANYONE HEARD THE TERM FLUAGE? WHAT IS IT? TALK THROUGH SLIDE BUILD. HOW CAN WE PREVENT FLUAGE? USE AN RFI, BETWEEN THE GI AND NC. USE SLIDE HIGHLIGHT THE INFLUENCE OF BEAD ARCHITECTURE ON RIM FIT. LOOSE: RIM TURNS INSIDE THE TYRE PROBLEM WITH AIR TIGHTNESS UNSEAT THE TYRE FROM RIM DURING CORNERING TIGHT: DAMAGE BEAD POINT ON FITTING (AIRTIGHTNESS) DIFFICULT TO FIT (MAY BE IMPOSSIBLE IN AUTO PROCESS. HOW IS INFLATION PRESSURE MAINTAINED ? Unlike the scientists and technicians, customers don’t think in terms of tire functions. How do they express their expectations? - Firstly, they want security when driving, this is a fundamental requirement. - Next they want driving pleasure: vehicle drivers should be able to go where they want to, the way