9号、12号单开道岔检查(国外英语资料).doc

9号、12号单开道岔检查(国外英语资料) Ordinary single-opening bifurcation check First, prepare for work 1, fill in the name of the check record book in advance, the number of the branch, the type of the switch and the inspection date and the inspection person. 2, confirmed that ruler, offset ruler whether in the metrological department appraisal period, such as not qualified period to/report, after the consent, just can use. The track gauge is marked on the track 35, and the gauge length of the gauge with steel tape measure is greater than plus or minus 1mm. Adjust when deviation is allowed. Second, basic homework Set up protection, report the assessor, and do the homework. To stand and look at the rails of the straight off-line of the branch at about 30 to 50 meters from the end of the tunnel. Horizontal visual-vision. If the tracks are found to be either low or low, it can be recorded in track, low and other. After 3, visual rails to high and low, return to check first (tongue rail slope before the finish line, the rail before tapping, positive and negative rail gauge whether their level of error correction is greater than + / - 1 mm, error is more than + / - 1 mm, adjusted). Step 4: check and record according to the sequence of the gauge and the back level. When examining the gauge, it is greater than 1435mm for +, less than 1435mm -. Outside inspection level, keep stocks: as a standard shares, song: outside (on the shares) as the standard shares, standard high for +, instead of -. (1) the first place: the end of the slope. Within 100mm range of the base rail front end. (2) the second place: the cusp. It is 50 to 100mm from the tip of the tip. (here the gauge is 43, 50-9 bifurcated to 15mm, or 1450mm; 443, 10mm, 10mm, 1445mm). (3) the third place: the spigot. In tongue rail plane cut end point, that is, with the part of the gauge widening (gauge widening here 43, 50-9 of 9 mm or 1444 mm; 43, 50-12 to 7 mm or 1442 mm) here do not check, check the gauge track gauge will be quickly