UPS的选择与使用(国外英语资料).docVIP

UPS的选择与使用(国外英语资料) Selection and use of UPS Liu Kewen The 1995-02-03 Here are some Suggestions for the selection and use of UPS. A, UPS selection As guarantee the power supply, UPS power supply is not only a simple sense of the uninterruptible power supply, its wide input voltage range, from 170 v to 250 v ac input, and by its output power quality is also very high. (1) output voltage stability: the backup sine wave output 5%, online 3%; (2) output voltage waveform distortion: the backup sine wave output 5%, online 3%; (3) output frequency stability: the backup sine wave output is plus or minus 1Hz, and the online type is plus or minus 0.5 Hz. (4) transient features: when the load changes from 0% to 100%, the output voltage varies by 4%, and the response time is about 10-40ms (online UPS). (5) it usually guarantees 150% load over 1 minute, 120% load over 8 to 10 minutes. (6) if the output is three phases, the negative sequence component of the output voltage is not greater than the positive component. Thats the general requirement for UPS. As for the specific selection of UPS, the following points should also be determined: The determination of UPS capacity: this depends on the magnitude of the load power. There are two methods for determining load power: Method of measurement: in the case of electricity, the load current is measured. If the load is a single phase, the load power is two times that of the phase current and the phase voltage. If the load is three phases, the load power is three times the product of the line current and the phase current. Estimate method: add up the power of each individual load, and multiply the sum by an insurance system, K (K, 1.1.3) as total load power. Using the above load power as the base, the capacity of the required UPS can be determined by considering the amount of allowance for later expansion of the device. 2. Determine the phase number: the single-phase power system voltage is 220 v, three-phase voltage is 380 v, the fr