新笔记本硬盘保护(国外英文资料).docVIP

新笔记本硬盘保护(国外英文资料) 1, the use of environment Dust in the working environment, dust will be adsorbed to the surface of the hard disk printed circuit board and the spindle motor. Hard disk work in a more humid environment, will reduce the insulation resistance. These two phenomena lead to the instability of computer work, heavy damage to some electronic devices, or some sensors that are sensitive to dust can not work properly. Therefore, it is necessary to keep the working environment sanitary and reduce the dust content in the air. In addition, users can not open the hard cover, or dust in the air into the tray, the read / write operation when the possibility of head scratching or disc head will greatly increase, so the hard disk failure must not be allowed to open the disc casing screw under normal conditions. In addition, as far as possible not to make the hard disk near the strong magnetic field, such as speakers, speakers, motors, radio and so on, so as to avoid the data recorded in the hard disk due to magnetization and damage. 2, pay attention to prevent high temperature, moisture-proof, anti electromagnetic interference Working condition of hard disk to be linked with life and temperature, temperature of the hard disk to use 20 to 25 degrees is appropriate, too high or too low temperature will make the clock oscillator frequency changes, or even cause the hard disk failure of circuit elements, the storage medium will record the error caused by thermal expansion. When the temperature is too low, the moisture in the air is condensed on the integrated circuit components, causing very serious short circuits. 3, the hard disk reading and writing can not be forced to power When the hard disk is read and written (the hard disk indicator is flashing continuously), the disk is in a state of high rotation. If the power is turned off at this time, it will cause a sharp friction between the head and the disk, thus damaging the hard disk. So, in the shutdown, we must pay at