汽车口令字母顺序复制芯片钥匙口令(国外英文资料).docVIP

汽车口令字母顺序复制芯片钥匙口令(国外英文资料) Car password, alphabetic copy, chip key, password A mode 1) do not compile new keys through coded keys, A) insert a key, turn on the switch, and a safety light will be on for about 10 minutes. B) turn off the ignition and turn on the lights within minutes after the lights are out. The warning light will be on for about 10 minutes. (c) repeat b) the procedure is last (about 30 minutes), the keys are fixed, all previous keys are void. 2) the new keys are coded by keys A) insert an encoded key, turn on the ignition, and then turn off. B) insert the new key within 15 seconds, and turn on the ignition. The warning light is lit for about 2 seconds, which tells you that you are encoding. C) repeat b) to prepare each new key. If you want to delete the key, proceed to step 1 B mode 1). No keys to use A) insert a key to be coded, turn on the switch, and a red light will flash for 15 minutes B) turn off the switch before the red light does not blink for 5 minutes, then turn on the red light for 15 more minutes C) repeat b) this process takes about 45 minutes, the keys are ready, and all the previous ones are deleted, 2). There are encoded keys A) insert the encoded key, turn on the switch, and then turn it off B) insert the new key within 15 seconds, turn on the switch, and the light will flicker for 2 seconds C) repeat the B for each new key) steps Delete key execution step 1 C mode 1. there is a key in use It can only be executed by the manufacturer through a TESTER device 2. there is a key in use A) insert an encoded key, turn on the switch, and then turn it off B) insert second encoded keys within 5 seconds, turn on the ignition, and then turn off. C) insert a new key within 5 seconds and turn on the ignition. The indicator light is lit for 3 seconds to indicate memory. D) repeat B for each new key.) Delete key execution step 1 Mode D and (D) One or none of the keys have been encoded in the A. system 1. insert the key to be coded (KEY1), turn on th