anchai(国外英文).docVIP

anchai(国外英文资料) Special construction plan for tower crane demolition First, tower crane settings 1, according to the actual situation of the project, set up a tower crane, the model is QTZ-40, located on the west side of the project. 2, the basic bearing capacity is greater than 200KN/m2, the depth of reinforcement is greater than 1.3 meters, and the error of the four anchor columns on the basis of slope and flatness is less than 1/500 (the level of the top of the foundation is less than 1/500). 3, tower crane power distribution box independently set, and set at 5 meters away from the tower. 4 、 the ground has been cleared and the barrier has been formed. Two tower crane safety demolition (1) allocation of resources 1, configure 12T car crane 1, and all kinds of slings, slings. 2, personnel allocation: Command 1, tower crane driver 1, electrician 1, installation personnel several. (two) assemble 1. Lift the first section in the middle of the four anchor columns, the standard section has stepped side in and out of the surface, and should be vertical to the building. 2, the second section of the standard section installed in the first section of the standard section, pay attention to the foot should be aligned up and down. 3. Assemble the rack. The surface of the cylinder on the jacket shall be aligned with the standard section with the stepped surface, and the climbing claws on the rack are placed on the bottom step of the base section. 4. Assemble the upper and lower supports, slewing mechanisms, slewing bearings, platforms and so on. Then, they are installed on the sleeve and are firmly connected. 5. The tower cap is connected with the upper support by the pin shaft, and the inclined plane of the tower cap is on the same side as the suspension arm. 6. The lifting balance arm is connected with the upper support by the pin shaft, and a counterweight of the 2T is hoisted at the third position forward from the tail of the stationary arm. 7. Hoist the cab and switch on