DISTALRA桡骨远端.pptVIP

  • 2
  • 0
  • 约1.64千字
  • 约 27页
  • 2017-07-03 发布于湖北
  • 举报
DISTALRA桡骨远端概要1

* AP view radiograph of an intraarticular distal radius fracture. Lateral view radiograph of an intraarticular distal radius fracture. BARE AREA EPL 2mc The bare area of the radius is identified. A 5-mm incision is made over the bare area of the radius. A fine clamp is used to dissect gently down to bone to avoid damage to neurologic and vascular structures. Once the clamp is on bone, two Ragnell retractors are used to retract the tendons to either side of the radius. A small key elevator is used to clean an area of bone for the pin cannulas. BONE Bone is visualized at the base of the incision, confirming that there is no danger to the superficial radial nerve or other structures. A cannula system is used for drilling and half-pin placement. After the hole is drilled, the inner cannula is removed and the pin is placed through the outer cannula. To determine the location of the second pin, a pin clamp is used. After both proximal pins are placed, fluoroscopy confirms the appropriate length. The distal pins are placed into the second metacarpal. The mark on the metacarpal indicates the first pin, placed near the base of the second metacarpal. The second pin is placed distal to this using a pin clamp as a guide to its location. The forearm after the two sets of pins are placed. The connecting rods are applied to the frame, then the initial reduction is performed. The initial reduction is performed by flexing the elbow, slightly supinating the forearm and pulling gentle traction. The frame is then tightened in this position and radiographs are obtained with 10 degrees of angulation in each direction. 10° *

文档评论(0)

1亿VIP精品文档

相关文档