D10R型推土机变速系统故障的排查(外国英语资料).docVIP

D10R型推土机变速系统故障的排查 Troubleshooting of speed change system for type D10R bulldozer 2009-4-2 (1) unable to walk Equipment management, equipment maintenance, inspection and diagnosis N6t China equipment management network OHX A D10R bulldozer cant walk, and the dashboard shows DIRLVROUT Equipment management, equipment maintenance, inspection and diagnosis N6t China equipment management network OHX CAL, that is, the direction bar exceeds the calibration range. The direction bar sensor is non-contact, and the possibility of damage is very small. It is likely that the PWM signal produced by the sensor is biased due to long-term use, resulting in the failure of the drive controller to interpret. Carters ET software is used on-line, and the FNR direction bar correction function is used to correct it. The fault code disappears and the machine returns to normal. The touch console in the D10R bulldozer cab also provides the FNR direction bar correction function, which can also be corrected and faster. Equipment management, equipment maintenance, inspection and diagnosis N6t China equipment management network OHX (2) lift switch fault; Equipment management, equipment maintenance, inspection and diagnosis N6t China equipment management network OHX A D10R bulldozer works normally, but the dashboard shows UPSHTSW Equipment management, equipment maintenance, inspection and diagnosis N6t China equipment management network OHX ERR, that is, the raise switch error. The shift operation of bulldozer is very frequent, and the switch of lifting gear is pressed more frequently, and the switch is damaged on the right. After checking, the line is normal and the switch is partly damaged. After checking, the normally open contact in the lift switch is normal, but the normally closed contact is open, so the shift operation is normal, but the fault code is generated. Since there is no spare parts for the time being, and the purchase of imported parts is very slow, we consider alternative methods