一产品细节图(Thedetailpicturesofhornet).PDF

RCRCM Hornet Assembly Instructions 一 ：产品细节图(The detail pictures of hornet) 二 ：装配过程(Assembly process) 1 ：把金属推拉杆剪断 ，只保留螺纹部分即可。(Cut off the linkage rods, only retain the threaded portion) 2 将螺纹部分的两侧与金属铁夹头连接好。（螺纹部分打螺丝胶 ，以避免松动。） Secondly, Connect well clevis with the two head of threaded portion. (Gluing the threaded portion to avoid loosening) 3 ：打磨出固定摇臂的位置 ，打磨至摇臂动作时不受到干涉即可。 Thirdly, Grinding out a position to fix control horn, until the control horn move freely. 4: 固定摇臂 ，确保摇臂不松动且足够坚固。 Fourth, Fixing the control horn to make it strong enough and not loose 5 ：分别打磨两襟翼舵机座靠近推拉杆侧的一角 ，打磨至推拉杆动作时不受干涉。 Fifth, Polished two flaps servo trays which near the corner of the pushrods side, until the pushrods active freely 6 将舵机座固定在安装槽内。 Sixth, To fix the servo tray into installed slot. 7 ：用铁钩把舵机延长线穿入机翼 ，并与舵机线连接好 ，然后固定舵机 ，盖上舵 机盖。 Seventh, With hook take wiring harness through the wings , and connect wiring harness with servo wiring well, then fixed the servo and cover the servo cover. 8 ：