单元十一(一)光的量子效应及光子理论（国外英文资料）.docVIP

单元十一(一)光的量子效应及光子理论 Unit Eleven (1) quantum effects of light and photon theory First, the multiple-choice question The red limit of the photoelectric effect of 1. metals depends on: [C] (A) the frequency of incident light; (B) the intensity of incident light; (C) the escape work of the metal; (D) the frequency of incident light and the work of the metal. 2. known to produce the photoelectric effect a monochromatic light to a metal surface, the metal is U0 if the potential escape (the electrons from the metal work need to work eU0), the monochromatic wavelength must satisfy: [A]? 3. a sheet of metal placed in a uniform magnetic field B with a red limit wavelength of. This monochromatic light, found electronic release, released by the electronic (quality of M, the absolute value of the power is e) in a plane perpendicular to the magnetic field within the radius of circular motion of R, then the light energy of the photon is: [B] 4. about the photoelectric effect, there are the following statement: (1) any visible light at any wavelength can produce a photoelectric effect on any metal surface; (2) if the same metal is produced by photoelectron, the initial energy of photoelectrons varies with the frequency of incident light; (3) the number of photoelectrons produced per unit time is different for the same metal due to the different wavelengths of incident light; (4) for the same metal, if the incident light frequency is constant and the intensity is doubled, the saturated photocurrent is doubled. The correct one is: [D] (A) (2), (3), (1), (2), (3), (4); (C) (2), (3); (D) (2), (4), (); 5., the intensity of I, the wavelength of X ray irradiation of lithium (Z=3) and iron (Z=26), if the same scattering angle, measured Compton scattering X ray wavelengths are, and their corresponding intensity are: [C] Two. Fill in the blanks 1. when the wavelength is 300 nm and the light is irradiated on a metal surface, the photoelectron energy range from 0 to the stopping voltage in the