电梯问答（国外英文资料）.docVIP

电梯问答 1. what are the eight systems of traction driven elevators? Main points： Traction system, guidance system, car, door system, weight balance system, electric drive system, electrical control system and safety protection system. 2. what safety facilities or protection functions should the elevators have? Main points: GB/T10058 specification in elevator technical condition: (1) fault or phase protection device or function of power supply system; (2) speed limiter and safety clamp linkage overspeed protection device. Electric protection device and speed limiter, rope rupture or relaxation protection device including speed limiter, safety clamp action; (3) a bottom buffer device, including a reset protector for an energy dissipation buffer; (4) a protective device that works beyond the upper and lower limits; (5) the electric interlocking device of the floor door and the car door comprises a door lock, an emergency unlocking and a layer gate automatic closing device and an automatic reopening device when the door is broken when the door is closed; (6) emergency operation and stop protection device; (7) the top of a car should be equipped with an overhaul and running device, and priority shall be given to the maintenance and operation device installed elsewhere. 3. what combinations of switches are used to prevent the trip from being protected? Whats the function of each? Key points: general is located in wells on the lower station near the switch, forced speed limit switch and limit switch. After the switch is arranged at the end of the switch station forced speed normal speed, switch operation, the car immediately forced into a low-speed operation, prevent the first process to protect the. When the car does not have a normal stop at the end station and touches the limit switch, the direction control circuit is immediately cut off so that the elevator stops running, but the elevator can still run in the opposite direction (safety direction) at this time. The limit s