发电厂汽轮机一些知识(国外英文资料).docVIP

发电厂汽轮机一些知识 First preparation 1 confirm the gas tightness test of generator. 2 confirmation of lubricating oil system for normal operation, barring outage. 3 make sure the sealing oil system is working properly and the hydrogen / oil pressure difference is normal. 4 make sure the hydrogen moisture detector is isolated. Two replace the air with CO2 1 connect the CO2 cylinder to the CO2 bus. 2 open the feeding mother tube to the hydrogen analyzer, manual door, hydrogen analyzer inlet, manual door, hydrogen analyzer, exhaust manual door. The hydrogen analyzer is put into the CO2 test loop 3 turn off the gas dryer inlet, manual and gas dryer, exit the manual door, turn on the gas dryer, and bypass the manual door 4. Turn on the feeding mother tube to the generator manual door, hydrogen discharge mother tube, manual master door, CO2 bus dryer, front and rear manual door, CO2 mother tube to generator, manual door one or two times. The remaining valves are closed. 5 send the power supply of CO2 electric heating device and put into operation 6 use pressure reducing valve to adjust CO2 flow to control the pressure and temperature, the pressure after the pressure valve is maintained at 0.5 ~ 0.8MPa. 7 adjust the feed from the mother tube to the flame eliminator, the hydrogen exhaust manual door opening, so that the gas pressure in the machine is maintained at 0.01~0.02Mpa 8 when the CO2 cylinder frost, can water shower. 9 when the purity of CO2 reaches 85%, the gas pressure in the generator is properly increased, and then the dead ends are operated. (such as hydrogen dehumidification device, oil and water detection alarm and pipeline dead angle, etc.) exhaust air at the dead corner 10 stop the CO2 heating device and disconnect the power supply. Three hydrogen operation 1 close the feeding line, manual sampling door, CO2 bus dryer, front and rear manual door, CO2 master tube to generator, manual one or two door, feeding mother tube to flame eliminator, hydrogen discharge manual